Yokogawa Data Acquisition with PID Control CX2000 Uživatelský manuál stáhnout pdf (Strana 30)

2-18

IM04L41B01-65EN

Batch

Click here (also selectable from [Setting] - [Engineering Mode Setting]).

Automatically increase the lot number by 1 at Memory Stop.

Use the lot number indication.

Header 1 to 3

Enter character strings (up to 64 characters) that are written to the batch and continuous

data files.

Calibration Correction

Canonlybespecifiedonmeasurementchannels.

Click here (also selectable from [Setting] - [Engineering Mode Setting]).

Set point number

Enter values.

Select the number of set

points.

Select channel.

Number of Set Points

Select the number of set points from [OFF] or [2] to [16].

Select [OFF] if you are not using the correction function.

Selectable Range of Measured and True Values

Channelsthataresettoscalingorsquarerootcomputation:–30000to30000(the

decimal point position depends on the channel setting)

All other channels: Selectable range in the specified range

For the measured value, set a value that is greater than the previous measured value. If

you enter a setting that does not meet these conditions, the [Number of Set Points] is set

to [OFF] when you store the setup data, print the setup data, or send the setup data to

theDXPusingtheCommunicator.

2.5 Confiuring the Engineering Mode

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 54 55

Žádné komentáře

Yokogawa Data Acquisition with PID Control CX2000 Uživatelský manuál Strana 30