Yokogawa PC-Based MX100 Uživatelský manuál stáhnout pdf (Strana 113)

4-2

IM MX180-01E

When the connection is established, information about the unit’s module

configuration is displayed.

To disconnect the connected MX100

To illuminate the 7-segment LED of the

connected MX100 to see which MX100 is

connected

Information about the connected MX100

Modules attached to the

connected MX100

If the specified IP address or host name is not correct, or the MX100 is connected

by another software program, the following dialog box opens.

Note

•

You cannot change the MX100 network settings using the Calibrator. Use the Integration

Monitor (MX100 Standard Software) to change the IP address and other settings.

•

If you change the module configuration before connecting with the Calibrator or if modules

that are not operating properly exist, X marks are displayed on the modules as shown

below.If you change the module configuration, use the Integration Monitor to reconfigure the

system.

• When using Windows XP, Windows Vista, or Windows 7 with the firewall enabled,

recognition is sometimes not successful even when clicking the Search button. To solve the

problem, see appendix 1. (The same problem may also occur if your anti-virus software is

using a firewall.)

4.1 Connecting the MX100

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 140 141

Žádné komentáře

Yokogawa PC-Based MX100 Uživatelský manuál Strana 113