Yokogawa Wireless Temperature Transmitter YTA510 Uživatelský manuál stáhnout pdf (Strana 8)

IM 01C50T01-01E

1-4

1. INTRODUCTION

1.1 Matching of DD and Instru-

ments

To setup the YTA via HART handheld communicator,

it is necessary that the correct version of DD(Device

Description) is installed in the communicator. The

matching of the instrument and the DD in the commu-

nicator can be checked by the following procedures. If

the correct DD is not installed in your communicator,

contact your nearest official programming site for

HART Communicator and ask for an update.

For the instruments or software other than the HART

handheld communicator, contact a vendor of each

instrument / software and ask for information.

1. Check the revision of the instrument.

1) Connect the communicator with the instrument.

2) Call "Review" display, and find the parameter

"Fld dev rev" there. The device revision of the

instrument is shown in it.

2. Check the revision of DD

1) Turn on the communictor without connecting

with the instrument.

2) Call "Simulation" display. [ Menu → 4.Utility →

Simulation ]

3) The list of the manufaturers is shown. Find

YOKOGAWA and select it.1

4) The list of the devices is shown. Find YTA and

check if the dev rev number shown there matches

the number confirmed in the step 1.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Žádné komentáře

Yokogawa Wireless Temperature Transmitter YTA510 Uživatelský manuál Strana 8