Yokogawa Data Acquisition with PID Control CX2000 Uživatelský manuál stáhnout pdf (Strana 244)

7-70

M-4659

Auxiliary Settings

You can set the control output DO when the communication buffer recovers, internal

switch status processing, and auto recovery of communication with Modbus master/

temperature controllers valid for serial communications. These settings are available

when serial communication is installed.

Click this tab

Recovery Status for Comm. Buffer

You can set the recovery operation for the control output DO/internal switch

communication buffer to be performed when the power is turned ON, or when recovering

to Operation Mode from Basic Setting Mode. The communication buffer is an internal

region for turning the DO/internal switches ON and OFF via communications.

Continue : Holds the status of the control output DO and internal switches

Clear: Clears the status of the control output DO and internal switches

Modbus Master/Exp loop

You can select whether or not to automatically recover communications with modbus

mice and temperature meters. If you select automatic recovery, you can also specify the

recovery interval. You can select one of the following intervals: 1 min, 2 min, 5 min, 10

min, 20 min, 30 min, or 60 min.

Specifying the Memory Data Out Mode

You can only specify to output memory via Ethernet or serial communications.

7.11 Network Settings

1 2 ... 239 240 241 242 243 244 245 246 247 248 249 ... 285 286

Žádné komentáře

Yokogawa Data Acquisition with PID Control CX2000 Uživatelský manuál Strana 244