Yokogawa ADMAG AXR Uživatelský manuál stáhnout pdf (Strana 103)

<8. OPERATION VIA HART CONFIGURATION TOOL (HART 5)>

8-1

IM 01E30D01-01EN

OPERATION VIA HART CONFIGURATION TOOL (HART 5)

ThisChapterdescribesthedevice(AXR)operation

proceduresusingaHARTcongurationTool(such

as FieldMate).

NOTE

For more details regarding the operations for

theHARTcongurationtool,refertotheHART

congurationtooloperationsmanual.

Note: HART is a registered trademark of the HART

Communication Foundation.

8.1 HART Protocol Revision

For the models with the output signal code “-J”,

HART protocol revision 5 or 7 is selectable. The

protocolrevisionissetasspeciedintheorder.

Howtoconrmprotocolrevisionisshownbelow.

Therearetwowaystoconrmtheprotocolrevision

set to the transmitter.

(1)Conrmationbythenameplate

The HART protocol revision at the time of

shipment is shown by the last number at the

serial number column of the name plate.

F0801.ai

XXX…XX 

5: HART 5

7: HART 7

(2) ConrmationbyusingHARTcongurationtool

Refer to 8.8.5.

IMPORTANT

Protocol revision supported by HART

congurationtoolmustbethesameorhigher

than that of the device.

Protcol revision

supported by HART

ongurationtool

5 7

Protocol revision of

the device

 

7 ×



 :

Communication OK

×: Communication NG

NOTE

In this User’s Manual, HART protocol revision

5 and 7 are described as HART 5 and HART 7

respectively.

NOTE

When the output signal code of the device is “-J”,

HART protocol revision can be changed. Refer

to subsection 8.8.5 about the procedure of the

revision change of HART 5 and HART 7.

8.2 Device Description (DD) on

aHARTCongurationTool

and AXR Device Revision

8.2.1 DD Revision and Device Revision

BeforeusingtheHARTCongurationTool(such

asFieldMate),conrmthattheDD(Device

Description)oftheAXRisinstalledinthe

CongurationTool.

• AXR:HART5

• Device type: 0x57

• Device Revision: 2

• DD Revision: 2

TheDDrevisionsforAXRandCongurationTool’s

canconrminaccordancewiththefollowingsteps.

If the correct DD is not installed in the HART

CongurationTool,downloadthemfromtheofcial

HART programming sites, otherwise, contact the

respectivevendorsoftheCongurationToolforits

upgrade information.

1. ConrmationofthedevicerevisionforAXR

(1) ConnecttheCongurationTooltotheAXR.

The device revision can be checked as

follows.

DD DeviceSetup→Review→Review4

→Flddevrev

2. Conrmationofthedevicerevisionforthe

HARTCongurationTool

(1) TurnonthepoweroftheCongurationTool

under the standalone condition.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 193 194

Komentáře k této Příručce

Žádné komentáře

Yokogawa ADMAG AXR Uživatelský manuál Strana 103

Komentáře k této Příručce

Související produkty a manuály pro Senzory Yokogawa ADMAG AXR