Yokogawa ADMAG AXR Uživatelský manuál Strana 181
- Strana / 194
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
<14. EXPLOSION PROTECTED TYPE INSTRUMENT>
14-4
IM 01E30D01-01EN
(3) Operation
WARNING
• “OPEN CIRCUIT BEFORE REMOVING
COVERS.”
• “SEALS ALL CONDUITS WITHIN 18
INCHES” in hazardous locations.
• When installed in Division 2, “SEALS NOT
REQUIRED”
• Take care not to generate mechanical
spark when access to the instrument and
peripheral devices in hazardous locations.
(4) Maintenance and Repair
WARNING
Theinstrumentmodicationorpartsreplacement
by other than authorized representative of
Yokogawa Electric Corporation is prohibited
and will void the approval of Factory Mutual
Research Corporation.
Non-hazardous
Location
Equipment
HAZARDOUS LOCATIONS DIVISION 1
18" (457mm) Max.
Sealing Fitting Conduit
F1403.ai
Magnetic Flowmeter
NON-HAZARDOUS
LOCATIONS
35V DC Max.
4-20 mA DC
Signal
Figure 14.2.1 Conduit Wiring
14.3 IECEx
WARNING
Only trained persons use this instrument in
industrial locations.
(1) Technical Data
*AXR025C–AXR200C
Applicable Standard:
I
EC 60079-0: 2007, IEC 60079-1: 2007,
IEC 60079-7: 2006, IEC 60079-11: 2006,
IEC 60079-31: 2008
Certicate:IECExDEK11.0053
Type of Gas Atmosphere Protection
Type of Protection:
Ex d e ia IIC T6…T4 Gb
SpecicationofProtection:
ElectrodeCircuit:Um=250V
Power Supply/Current Output: 42Vdc max., 4 to
20mA,Um=250V
Digital Output: ON; 2Vdc, 120mA max., OFF;
30Vdcmax.,4mA,Um=250V
Excitation Circuit: 29 V max.
Enclosure: IP66/IP67
Process Temperature:
Temperature
Class
Maximum Process
Temperature
Minimum Process
Temperature
T6 +70°C (+158°F) –30°C (–22°F)
T5 +85°C (+185°F) –30°C (–22°F)
T4 +130°C (+266°F) –30°C (–22°F)
Ambient Temp.: –30°C to +55°C
(–22°F to +131°F)
Type of Dust Atmosphere Protection
Type of Protection:
Ex tb IIIC T90°C, T110°C, T130°C, Db
SpecicationofProtection:
ElectrodeCircuit:Um=250V
Power Supply/Current Output: 42Vdc max., 4 to
20mA,Um=250V
Digital Output: ON; 2Vdc, 120mA max., OFF;
30Vdcmax.,4mA,Um=250V
Excitation Circuit: 29 V max.
Enclosure: IP66/IP67
Process Temperature:
Maximum Surface
Temperature
Maximum Process
Temperature
Minimum Process
Temperature
T90°C (+194°F) +70°C (+158°F) –30°C (–22°F)
T110°C (+230°F) +85°C (+185°F) –30°C (–22°F)
T130°C (+266°F) +130°C (+266°F) –30°C (–22°F)
Ambient Temp.: –30°C to +55°C
(–22°F to +131°F)
- IM 01E30D01-01EN 1
- Contents 2
- EQUIPMENT 6
- 1. INTRODUCTION 7
- 1.1 Using the Magnetic 8
- Flowmeter Safely 8
- 1.2 Warranty 9
- 1.3 ATEX Documentation 10
- 2. HANDLING PRECAUTIONS 11
- 2.4 Installation Location 12
- Precautions 12
- 3. INSTALLATION 13
- 3.2.1 General Precautions 15
- 40 mm (1.5 in.), Wafer Type 17
- <3. INSTALLATION> 18
- 4. WIRING 25
- Waterproof gland 26
- Drain valve 27
- F0406.ai 27
- 4.4 Grounding Connection 28
- 4.5 Wiring Connections 29
- 4.6 Wiring Procedure 30
- <4. WIRING> 32
- Magnetic 34
- Recorder 35
- AXR Terminal 36
- Distributor, etc 37
- (5) Installing the Cover 39
- (USING THE DISPLAY UNIT) 40
- F0501.EPS 41
- 5.1 Operating Panel 41
- CongurationandFunctions 41
- SETESC INC 42
- DEC/SHIFT 42
- P:Protect 43
- B:Easy Setup 43
- C:Basic Setup 43
- 5.2.2 Setting Mode 44
- F0504-2.EPS 45
- F0505-2.ai 47
- F0506-1.ai 47
- F0506-2.ai 48
- 6. PARAMETER DESCRIPTION 49
- 6.3 Parameter List Overview 50
- 6.4 Parameter Description 64
- Setting Function 67
- No Execution No execution 67
- Meter factors 68
- Upper 2 digits 71
- Lower 6 digits 71
- Ranges Switching 74
- 5.6mA(10%) 80
- 18.4mA(90%) 81
- Default setting (Enable) 88
- Write protection (Protect) 88
- Default setting 88
- After password setting 88
- 6.5 Alarm Functions 89
- 6.5.4 NE-107 status 94
- 7.1 BT200 Basic Operations 95
- ( B ) ( y )( o ) 96
- ( m )( I ) 96
- 7.2.1 BT200 Connection 97
- ( ) key 98
- ( ) 98
- “FI-1101” to “FI-1201.” 102
- XXX…XX 103
- 5: HART 5 103
- 7: HART 7 103
- Distributor 104
- 8.6 Data Renewing 105
- 8.4 Basic Setup 105
- 8.5 ParametersConguration 105
- 8.8 HARTSpecicFunctions 106
- 8.8.2 Fixed Current Output 107
- 8.8.3 Burst Mode 107
- 8.8.4 Multidrop Mode 107
- (continued on next page) 110
- IMPORTANT 121
- Device Information 122
- 9.8 HARTSpecicFunctions 123
- 9.8.2 Trim Analog Output 124
- 9.8.3 Burst Mode 125
- 9.8.3.2EventNotication 128
- 9.8.4 Multidrop Mode 129
- F0910.ai 135
- 10. ACTUAL OPERATION 138
- 21:Adjustment 20mA 139
- M:Adjustment 140
- 10:Auto Zero Exe 140
- 11:Autozero Time 140
- Now Auto Zero 140
- Executing 140
- 11. MAINTENANCE 141
- 11.2 Components Replacement 142
- <11. MAINTENANCE> 143
- 11.3 Setting of Switches 145
- 11.4 Adhesion diagnostic 146
- Dielectric Strength Test 149
- 11.7 Troubleshooting 150
- 11.7.2 Unstable Zero 151
- 12. OUTLINE 153
- Alarms and Setting Alarms 155
- Flowtubes 156
- HAZARDOUS AREA CLASSIFICATION 157
- Spaninm/s(ft/s) 158
- 25 to 50 mm (1.0 to 2.0 in.) 160
- (flange type, wafer type) 160
- 65 to 200 mm (2.5 to 8.0 in.) 160
- <12. OUTLINE> 161
- Electrical 167
- Connection 167
- Indicator 167
- Electrical Connection 167
- Unit: mm (approx. inch) 171
- General-purpose Use; 176
- Explosion Proof Type; 176
- INSTRUMENT 178
- Terminals 179
- 14.2 FM 180
- 14.3 IECEx 181
- 14.4 TIIS 183
- Digital output circuit 185
- Supply/ Output signal circuit 185
- Installation 186
- A1.2.7 Startup Time 187
- A1.2.8 Firmware Update 187
- A1.2.9 Reliability Data 187
- A1.3 Denitionsand 188
- Abbreviations 188
- A1.3.2 Abbreviations 189
- FOR TIIS FLAMEPROOF EQUIPMENT 190
- Apparatus 191
- 5. External Wiring for 191
- Flameproof Apparatus 191
- 7. Selection of Cable Entry 193
- Devices for Flameproof Type 193
- Revision Information 194
Související produkty a manuály pro Senzory Yokogawa ADMAG AXR
Senzory Yokogawa AXFA14G/C Uživatelský manuál
(76 stránky)
(76 stránky)
Senzory Yokogawa ADMAG AXF Uživatelský manuál
(112 stránky)
(112 stránky)
Senzory Yokogawa ADMAG AXF Uživatelský manuál
(133 stránky)
(133 stránky)
Senzory Yokogawa AXFA14G/C Uživatelský manuál
(18 stránky)
(18 stránky)
Senzory Yokogawa AXFA14G/C Uživatelský manuál
(123 stránky)
(123 stránky)
Senzory Yokogawa ADMAG AXF Uživatelský manuál
(107 stránky)
(107 stránky)
Senzory Yokogawa digitalYEWFLO (DY) Uživatelský manuál
(126 stránky)
(126 stránky)
Senzory Yokogawa digitalYEWFLO (DY) Uživatelský manuál
(173 stránky)
(173 stránky)
Senzory Yokogawa RAGL Uživatelský manuál
(2 stránky)
(2 stránky)
Senzory Yokogawa RAGN Uživatelský manuál
(46 stránky)
(46 stránky)
Senzory Yokogawa RAKD Uživatelský manuál
(72 stránky)
(72 stránky)
Senzory Yokogawa RAMC Uživatelský manuál
(136 stránky)
(136 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce